/

ESP8266 Wifi based 2 channel AC Switch

ESP8266 Wifi based 2 channel AC Switch
 
Quantity:
R 140.00 each Estimated Dispatch Tomorrow Total Cost R 140.00

Description

ESP8266 WiFi Board for IoT Projects (similar to the Sonoff Dual)

CAUTION!!!!!
This board has exposed high voltage AC tracks and should not be programmed while plugged into mains voltage. Any fault on the board can cause serious damage to your computer.
Do not supply this unit with mains while any USB-TTL programmer is plugged in or while the board is not secured and enclosed in the provided enclosure.

 

Hardware Features
Based on the ESP-12F ESP8266 Wifi module.
802.11 b/g/n Wifi.
Integrated low power 32-bit MCU.
4MB Flash.
On-board AC-DC power module (85 - 265VAC).
Relay: HF32F-G-5-HS, 10A 250VAC (PCB traces supports max 2A).
Enclosure: 111 x 42mm.
Two on-board buttons.
Two on-board LEDs.
Some of the ESP8266 module's pins is available on-board.
Reserved footprint for a DHT22 sensor (recommended to mount DHT sensor outside the enclosure).

The ESP8266 can be programmed using our CP2102 USB-TTL programmer that can be found here.
Supported in Tasmota firmware (Select Electrodragon in configuration). Other firmware may also be used but may require additional setup.

The cables on the output terminals conflicts with the enclosure, check cable routing.
Inductive loads may restart this board, rather use the IL version for inductive loads (see below for link)

This relay board passes the AC input to the output relays (designed for inline use).

 

Series of ESP Relay Boards:
Wifi IoT Relay Board: AC Mains Power ON/OFF
ESP Relay Board IL: Optimize for inductive loads
Wifi IoT Relay Board VDC: DC Power Supply, DC (or AC) ON/OFF
Wifi IoT Relay Board SPDT: Output not connected to input), DC or AC On/OFF
ESP LED Strip Board: Similar to H801 Controller for LED strips (4 x MosFET)

Difference of this version (SPST) and the SPDT version:
The output of the SPST relay is the same as the AC main input voltage. The relay only acts as an inline AC switch.
The output of the SPDT relay is not connected to the AC mains input voltage, the relay can act as a switch for any other circuit, can be either AC or DC power.